Motion Sensor Plug

A motion sensor flood lights are normally used to reduce the risk of theft in the house. The best thing a thief is necessary to have a dark outside the house. The best thing about these projectors is that motion is detected the dark and automatically activated. These lights have a special cell that are designed off during the day to conserve electricity. Not all projectors, but few have the motion sensor in them that adjustable timer lets you set the activation time for fires to ignite.

motion detector lights are very affordable and you can have it for $ 40 in a local home improvement store. Always choose a projector that matches your style of existing flood Light. Here are some easy steps to set up a flood light motion detector.


Steps

1. Before starting the installation of a floodlight motion sensor, make sure you have turned off the power supply into the wall outlet.

2. Now take a screwdriver and remove the mounting bracket existing projector. You are now ready to install the new support for the new projector. Take a drill and drill holes for dowels and screws. Keep the new medium on the place and tighten with plastic anchors and screws. Make sure the new media is secured.

3. Remove the cover from the wiring box on the pressure box and also remove the screws from the sealed gland.

4. Removing the cover from the wiring box and screws on the gland seal will allow you to route the power cable into the gland and the pressure block.

5. To make sure the gasket is properly equipped, you must remove the insulation portion of the power cable. It is normally 6 to 8 mm thick.

6. Once you've stripped the insulation of the cable, connect the brown wire (live wire) to terminal L and the blue wire (neutral wire) to terminal N.

7. Now, use the pressure block to fit the power cord with 2 screws. Tighten the gland, before replacing the lid of the box wiring.

8. You are now ready to install the new projector on the bracket. When installing the projector, you must be careful that the cable must not come into contact with flood light. You can use clips to attach the cable to the wall near the projector.



Points to remember

• Do not forget to turn off the power switch before working on the supports.
• Avoid installing the light rainy days.
• Always install an appropriate circuit breaker with the new projector.
• Stand at a distance of 80 cm from the projector.
• Make sure the head of the flood light and motion sensor is secured to the base.