Motion Sensor Wiring

Hello everyone ...

I need to wire 2 lights motion sensor so that only one can go at times and they either cut or immediately after a second or two.

Thus, for example ... you're standing in a room ... you can go to one side of the room and light it. Another person walks on the other side, but it does not light. When you try to leave the area is lit, it goes out immediately or within a few seconds. This is so the two lights may be lit at the same time ... even with several people.

I know it's a difficult question, but I need this game for anything I do. Ah! please help! ha

Thank you very much in advance!

You need a little more complex circuit.
Here's an idea
http://img6.imageshack.us/my.phpaimage=2 ...
The circuit so that the only light sensor can be active when the auxiliary uses two Ralys to do the job.


Activation eg L1 (light sensor), the relay R2 energizes and one of the pairs of contacts became a light on all the other breaks a circuit for the second light sensor so that it can not be activated.

You have a problem, sensors rely on movement to detect someone. If once they trip the light they stop moving, the light goes out. Someone can then approach the other light and turns on what you do. You will need independent detectors, and to connect to a timer circuit each. Each timer would need to control a relay to turn the other detector. Thus, the wiring between them will be very complex with the power of each timer and relay, passing through the detector in front. Then, the power of the fire being fed to his "own light.